![]() So, I'm not sure if I'm going to keep on the path of trying to make this work or if I'll just deal with getting ethernet or coax run between the locations. Plus, I can't guarantee that the modem channel(s) won't move around. It can actually make performance worse by allowing line noise ingress at those higher frequencies that. MoCA Access is a viable solution for numerous market segments addressing network access. It is a fiber extension technology that uses the in-building coax and is capable of 2. I found a filter that will essentially block out any frequencies higher than 650-ish Mhz or so (because my cable system likely is 750-900 Mhz in total bandwidth, and I also don't need to backfeed the Dish MoCA out to the cable company). MoCA recently announced its network access specification called MoCA Access. The hitch there is that the highest frequency my cable modem is currently using is 627 Mhz. The problem I have, though, is that I only have one coax run at my modem/router, so I need to figure out a way to get the signal from the cable company over there as well. So, I definitely will need the Dish bridge (HIC). Satellite signals are up in the 950 to 3Ghz range, Dish MoCA is in the 650-875 Mhz range, and my Actiontec "cable compatible" MoCA bridge uses 1125 to 1525 Mhz. I finally found a source that had the frequency ranges for everything. install a MoCA filter on the coax input of the cable modem/gateway, to protect the DOCSIS 3.1 modem from MoCA signals (the simplest of the workarounds, most suitable when a modem/gateway is being disrupted by MoCA signals, though won't work if/when a provider begins actually using frequencies in the DOCSIS 3.1 range - noting that a MoCA. MoCA technology occupies unused frequency spectrums. Will that work? And do I need a diplexer? Or does the Solo Node completely isolate all non-MoCA frequencies from crossing over to the satellite side? So, what I'd like to do is connect the Joey connection off my Solo Node into the splitter coming off my cable line, to bridge the two MoCA networks. ![]() 6) moca filter where service enters the house. 5) ideal 3 way 2 ghz splitter in the outside junction box. 3)translite tl-mc84 2.5 adapter at each end. 1)I have 1 gigabit speed vz fios internet. I also want to bridge from the Hopper into a switch in my entertainment center so that all of my other stuff like Xbox and Apple TV can utilize the wired MoCA connection. Im having MOCA 2.5 speed issues at every endpoint of my coax. I've included a diagram on this post to demonstrate what I want to accomplish, but essentially my wifi is not reliable at my TV location, and I want to use my old MoCA bridge to get internet on the coax network at my modem. My question is, is the MoCA that Dish uses compatible with standard MoCA that I'd use with the cable company? I know that DirecTV "DECA" is just MoCA, but on incompatible frequencies. Hey guys, just got Dish installed last week after a disastrous one-month stint of trying to cut the cord (had dropped cable and decided that I wanted Sling to bridge the gap between the flexibility I wanted as a "cord cutter" and an actually reliable service)
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |